Kling-freitag K&F CD 44 Digital System controller User Manual download pdf (Page 7)

User's manual K&F CD 44 Digital System Controller

2. Safety Instructions

Danger

This symbol indicates the possibility of life-threatening danger and a health risk for persons.

Not following these instructions may result in serious health problems including potentially

fatal injuries.

Warning

This symbol indicates a possibly dangerous situation.

Failure to follow these instructions can lead to malfunctions in the product or in the

environment.

Caution

This symbol gives instructions for the proper use of the described products.

Failure to follow these instructions can lead to malfunctions in the product or in the

environment.

3. General Safety Instructions

Warning

Do not install devices in any of the following places:

• where the units are permanently exposed to direct sunlight.

• near other heat sources or open fire.

• where the airflow for cooling is blocked.

• where the devices are exposed to high moisture.

• where the devices are exposed to strong vibrations and dust.

Power supply

Before connecting to the power supply system, check if the local voltage matches the voltage

marked on the device. The device then needs to be adapted to the required mains voltage by

Kling & Freitag or an authorized service centre. Connect the device under any circumstances,

to an unauthorized power supply source. This could irreparably ruin the device.

Make sure that the power outlet supplies a ground connector, which must be connected to

the device via the PE conductor of the power cord!

All devices interconnected over signal lines with connection to a protective earth must be

connected to a common protective earth. If not, there is a risk of an electric shock or the

destruction of the connected equipment. The power plug must always be used to disconnect

from the power supply. Furthermore, the power plug must be easily accessible for use at all

times.

Protection of electrical cables

Power cables should be routed so that they are protected against impact damage and tensile

stress caused by jamming between objects.

Transportation

When transporting the device, make sure that it is protected from vibrations.

Cleaning

The equipment should only be cleaned with a damp cloth when it is not plugged in.

Pauses in use

The power cord should be disconnected from the power source during longer pauses in use.

Intrusion of liquids

It should always be ensured that no liquids get into the device.

1 2 3 4 5 6 7 8 9 10 11 12 ... 76 77

Comments to this Manuals

No comments

Kling-freitag K&F CD 44 Digital System controller User Manual Page 7

Comments to this Manuals

Related products and manuals for Audio Kling-freitag K&F CD 44 Digital System controller