Kling-freitag K&F CD 44 Digital System controller User Manual download pdf (Page 26)

User's manual K&F CD 44 Digital System Controller

7.5 Setups in editing mode

All settings are executed in real time.

There are three different editing modes:

1. Editing mode with one editing line

2. Editing mode with several editing lines

3. Selection Mode with selection lines

7.5.1 Editing mode with one editing line

In order to follow the aforementioned example, we will show the editing mode with one

editing line: the editing mode Contrast of the submenu item Display.

Changing Parameters

The underline marks if you can change the parameters in increments of 1 or 10. (In other

editing modes, further increments are also possible). In the illustration below, the underline is

below the zero, this means, the ones digit will be changed.

You can change the parameters in increments of one by turning the knob f.

If you wish to change the parameters in increments of 10, then push the knob once so that

the cursor blinks. In this case it is blinking in the ones place. Turn the knob to the left so that

the underline is under the tens place (the cursor is no longer blinking). Then you can change

the parameters in increments of 10 by turning the knob.

Confirm changes

To confirm the changes made in the current editing mode, push the EXIT button 2x. The

screen returns to the preceding submenu. The settings are kept until a new setup is loaded

or until the settings are changed. Changes that have been made in fewer than 10 seconds

before the device is shut down are lost after it is turned off. Please wait at least 10 seconds

after having made final changes before turning off the controller. EXIT

To permanently store changes in a setup, save the setup at: <Setup » Save As>.

The following changes are not saved with a setup and are, therefore, maintained even after a

setup has been loaded: InSelect, EQ 31-Band, Display, IP-Address, Units.

Undo (cancel changes)

To undo the changes made in the editing mode, turn the knob while the cursor is blink-

ing (push the EXIT button 1x) to the left until the position indicator (arrow) points to the

undo symbol. Then push the knob. The entries are cancelled and the screen returns to the

preceding submenu. EXIT

Example of a display in the editing mode with one editing line:

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 76 77

No comments

Kling-freitag K&F CD 44 Digital System controller User Manual Page 26