Kling-freitag K&F SEQUENZA 5 W User Manual Page 48

  • Download
  • Add to my manuals
  • Print
  • Page
    / 88
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 47
User's manual K&F SEQUENZA 5 incl. accessories
KLING & FREITAG GMBH © 2015 Version 4.1 Page 48 of 88
Detailed information for connecting the speakers and configuring the K&F system amplifier
TOPAS or the K&F SystemRack is in the hardware manuals.
9.4 Lifting the Array
Warning
If a BGV (government safety organisation) C1 or a D8+ motor is used, the SEQUENZA 5 system
is intrinsically safe and does not require any secondary securing. If the SEQUENZA 5 system
is, however, to be hung on another motor, then secondary securing is necessary. This can be
attached to the 3.5t shackles and must be implemented with zero drop height. Instructions
for the correct use of secondary securing with zero drop height are in the standard VPLT
(Assoc. of Media and Event Technology) SR 2.0 "Preparation & use of electric chain hoists".
Caution
See the instructions in chapter 'Safety Instructions' from page 14 and in the corresponding
sub-section 'Safety Instructions for Flown Setup' from page 15.
Risk of crushing hands!
The speakers move towards each
other during lifting.
During hoisting - as long as the motor
is running - the specifications of the
BGV (government safety organisation)
C1 are not fulfilled.
Ensure that nobody can step below
the suspended systems.
These instructions are valid for arrays consisting of up 15 SEQUENZA 5 W speakers or 10
SEQUENZA 5 B speakers and also for mixed arrays with SEQUENZA 5 W and SEQUENZA 5 B.
The simulation software SEQUENZA 5 must always verify the number of speakers.
1. To prevent the castor base
from being pushed up if a
load is outside of the castors,
pull the rear-most castor
base out from underneath
the lying speakers until the
red marking is completely
visible.
2. Hook the load hook of
the hoist chain (i.e. of the
hoist motor) into the load
adapter's shackle and begin
to lift the array carefully.
Caution
Make sure that the
speaker array does not
pull the castor bases up
with them.
During lifting, the spring
bolts snap into their pre-
determined position with a
clearly audible clicking noise.
Page view 47
1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 87 88

Comments to this Manuals

No comments